Honda Civic: How to Change Manual Transmission Fluid
※ Download: Honda manual transmission fluid
However, the manufacturer recommends the use of their MTF when changing the fluid. Locate the filling bolt and the drain bolt on the transmission.
This oil is similar to a 10W-30 or 10W-40 viscosity engine oil, and this oil can be substituted temporarily. Find out how to do just that here.
Honda Civic: How to Change Manual Transmission Fluid - We provide additives for your specific make and model, so whether you need a transmission fluid change for Mustang cars or a Toyota Camry transmission fluid flush, you're sure to find everything you need when you rely on AutoZone. Pour each bottle of down the funnel.
The transmission dipstick is connected to the bottom of the transmission fluid tank cap. The transmission fluid should have a pinkish red color. If the transmission fluid is any other color than pinkish red, you need to take the Honda car in for serious maintenance. Remove the oil filler bolt, which is located behind the axle toward the firewall. Insert your finger into the hole. The oil level should be just up to the bottom of the filler hole. Add engine oil as necessary to achieve the appropriate level. Insert a funnel into the filler hole and slowly add oil until it runs out of the hole. Install and tighten the bolt. Automatic Transmission Drive the vehicle until it reaches normal operating temperature. Park it on solid, level surface. Remove the transmission dipstick. It is located below the top radiator hose and has a yellow rubber coating on the handle. Wipe it clean and reinsert it. Remove the dipstick and hold it parallel to the ground. The fluid level should be within the cross-hatch area. If the level is low, insert a funnel into the hole and slowly add fluid to bring it to the correct level. Turn off the engine. Locate the transmission dipstick cap on the side of the transmission and twist the cap in a counterclockwise motion to remove the cap from the transmission. Wipe the dipstick off with a shop rag. Replace the dipstick into the transmission and tighten the cap in a clockwise motion. Remove the dipstick from the transmission and look at it. Replace the cap onto the transmission and tighten it. Locate the transmission dipstick to the side and rear of the engine. Make sure it isn't the engine oil dipstick; the engine oil dipstick is at the front of the engine. Pull the transmission dipstick out, wipe the tip of it with a towel and insert it completely back into the tube. Pull it out again and look at the end of the dipstick. Look for oil at the end of the stick between two marks. If there's no transmission oil on the dipstick at all or it's below the lowest line, the transmission needs oil. If the oil level is above the highest mark, the transmission is filled too much and should be drained. Manual Honda Civic Transmission Place the jack under the front of the car and jack it up. Pace jack stands behind the front tires on the frame of the car. Get under the car and find the side of the transmission where the two drain plugs are located. The bottom plug is the transmission drain and the top plug is used to check the oil level. Use a ratchet and socket to remove the top plug from the transmission. Put your finger in the hole. If your finger can touch transmission fluid, the level is good. If you cannot reach any fluid through the hole, the level is too low. If fluid pours out of the hole when you unplug it, the level is too high. Start and warm the engine until it reaches operating temperature and the cooling fan comes on. Move the transmission shift selector through every position and back to park. Apply the parking brake and block the rear and front wheels. Open the hood of your car and locate the transmission dipstick. In most models, you will find the dipstick at the rear and to the side of the engine. Some transmissions have a dipstick handle marked with the words Transmission Oil, or come with a rounded, orange-colored handle. Pull the dipstick and wipe clean the tip with a clean shop rag. Insert the dipstick back into its guide tube. Pull the dipstick again, hold the tip on a clean shop rag and inspect the oil at the tip. The oil should be clear with a reddish color to it. If the oil looks dirty or smells burned, change the transmission oil. Look at the oil closely and make sure there are no metal, dirt, moisture or fiber particles in it. These particles might come from internal parts' wear. If left in the oil, these particles may accelerate parts' wear and even cause transmission failure. Change the transmission oil if it is contaminated. Make sure the level of the oil in the dipstick reaches the full mark. If the oil is between the Add and Full mark, add only half a quart of the manufacturer recommended transmission oil. If the oil is at the Add mark, add a quart of oil. Add oil through the dipstick guide tube using a funnel and check the oil level again. Replace the dipstick in the guide tube, close the hood and turn off the engine.
Changing Honda manual transmission fluid is not a difficult task in my opinion. This is why you should change your filter—as well as your ATF—every 25,000 miles. Once you place an order, you or someone you know can pick it up at a Sears store, have it shipped to over 100 countries—whatever is most convenient for you. If you favor automatic transmissions, automatic transmission fluid ATF has the ability to function effectively under a wide range of operating temperatures. This article applies to the Honda Civic 1992-2000. At AutoZone, you can find top-grade transmission fluid, so you don't have to worry about any worn-out gears while you're shifting. The oil should be clear with a reddish color to it. Pull the dipstick and wipe clean the tip with a clean shop rag.
